|
Home
PSI Self-Inking
Stamps
Maxlight Pre-Inked
Stamps
Hand Stamps
Custom Craft Stamps
Self Inking Daters
Monogram stamps
Notary Stamps
Signature Stamps
Bank Stamps
Notary - Corporate
Engineer - Architect
Seal Stamps
Stock Office Stamps
Ink for Stamps
and Stamp Pads
Re-inking Instructions
Stamp Pads
Stamps Order Forms
Our Brochure
About Us / Contact Us
Shipping/Return Policies
Our Customer Comments
|
| Use only Maxlight Ink and follow the directions below for our PSI Self-Inking Stamps, and Maxlight Pre-Inked Stamps |
|
PSI
SELF-INKER Re-inking Instructions
|
|
|
With the bottom cover off, push firmly on one of the two ends and slide out the little “drawer” that holds the stamp plate and ink cartridge. Drip a few drops of Maxlight Ink (not too much!) into the slots on top. Carefully reinsert the drawer/cartridge box. Set the stamp aside for a couple of hours to give the ink time to distribute down throughout the cartridge. |
MAXLIGHT
PRE-INKED STAMP Re-inking Instructions
|
|
|
Remove
the burgundy handle (pull hard, it will not come off easily the
first time)
and drip a few drops of Maxlight
ink (not too much!) into each of the two side holes.
Be sure the bottom cover is ON - then replace the handle by pushing
down on the top firmly. Set the stamp aside for a couple of hours
to give the ink time
to distribute down throughout the cartridge.
|
|
PLEASE
CALL US IF YOU NEED ANY HELP - (808) 874-0262 |
|
We make our stamps in-house! That way, you get your order sooner and
we are able to offer you a lower price because there is no middleman.
|
