With the bottom cover off, push firmly on one of the two ends and slide out the little “drawer” that holds the stamp plate and ink cartridge. Drip a few drops of Maxlight Ink (not too much!) into the slots on top. Carefully reinsert the drawer/cartridge box. Set the stamp aside for a couple of hours to give the ink time to distribute down throughout the cartridge.

Remove the burgundy handle (pull hard, it will not come off easily the first time)
and drip a few drops of Maxlight ink (not too much!) into each of the two side holes.
Be sure the bottom cover is ON - then replace the handle by pushing
down on the top firmly. Set the stamp aside for a couple of hours
to give the ink time to distribute down throughout the cartridge.

---